Stupidity has no cure

I asked him. Based on the list you have here, does that mean that I only have 3 types of pen-width to select from? (Note: Pen-width is basically a function in AutoCAD that allows you to draw lines in different thickness.)

"0.1, 0.2 and 0.3?" I asked. "3 types in all?"

"No, there is another pen-width 0.1 that you can use!" he replied.

"Wait. 3 types, as in 0.1, 0.2, 0.3, is already inclusive of 0.1. What are you talking about?!" I raised my voice.

"Yah~ (plus annoyed face) 3 types AND 0.1." he raised his voice one notch higher than mine.

"Ok. Which 3 are you talking about?"

"0.1, 0.2, and 0.3!"

"Then where did the 'AND 0.1' comes into place??!"

"Yah lah! And one more 0.1 lah!"


Nabei. What the hell is he saying? Quoting my brother, stupidity has no cure.

Then again, impatience (*raise hand* guilty as charged) has no cure either. *Sheepish laugh*